Autronica AUTROSAFE Self Verify BS-310 User Manual

Fire Alarm Control Panel, BS-310/320
Operator Panel, BS-330
Protecting life, environment and property...
In the Event of a Fire Alarm
One or several fire detectors or manual call points
in one or several detection zones are signalling a
Fire Alarm.
1 OFFICES
2 CANTEEN
3 WORKSHOP
FIRE ALARMS
19:23
Total: 3
(Display Picture - Example)
Actions to be taken - Operation Mode
1
Follow all precautions described in the
local fire instructions, step by step.
2
To silence the internal buzzer, press the
black Mute Panel button
3
Press
4
Observe the zone(s) in Alarm state on the
display.
If you need to find out more detailed zonal / point
information before investigating the scene(s), follow the
General Procedure, Step 4, a) to e) on the last page of
this folder, How to View Detailed Information.
If not, go directly to step 5.
5
Investigate the scene(s) and carry out the
necessary actions.
6
To silence all alarms, press the red
Silence Alarms button
To manually resound the alarm zones, digit 1
(RESOUND) can be pressed.
When the fire is extinguished and all necessary repair
work is implemented (smoke is exhausted, new glass
replaced in the manual call-points, etc.), the system
should be returned to normal operating mode.
7
Press the green Reset button
If there are points still signalling an alarm after system
reset and no actions are taken, the points will
automatically be reactivated after a predefined timeout.
If you want to disable the point(s) before timeout - for
example, a manual call-point still signalling alarm -,
press
A point can also be reactivated (digit 3) at any time after
the disablement. To reset the system, repeat step 6 and
7.
Step
Interactive Fire Alarm System
Release 3
P-ASAFE-SH/LE, Rev. A, 010531
NOTE: To operate the panel, turn
the key to the left
(Access Level 2).

Autronica AUTROSAFE Self Verify BS-310 Specifications

General

Category	Fire Alarms
Current Consumption (standby)	0.3 mA
Operating Temperature	-20°C to +70°C
Compatibility	Compatible with Autronica fire alarm systems
Technology	SelfVerify
Humidity Range	0% to 95% RH (non-condensing)

Summary

Responding to a Fire Alarm

Fire Alarm Response Steps

Detailed procedure for responding to a fire alarm, including silencing, investigation, and resetting the system.

Panel Access Instruction

Guidance on operating the fire alarm panel by turning the key to Access Level 2.

Fire Alarm with Alarm Delay

Alarm Delay Response Procedure

Steps to manage fire alarms originating from a delayed action detection zone.

Responding to a Fire Warning

Fire Warning Response Procedure

Procedure for handling fire warnings (prealarm/early warning) from detection zones.

Handling System Faults

Fault Handling Procedure

Actions to take when the system indicates a fault, including notification and acceptance.

Toggle Menu and Operation Modes

Instructions on switching between menu and operation modes using the Menu Button.

Viewing Detailed Information

Accessing Detailed Information

Guidance on how to view detailed zonal and point information from the operation mode.

General Procedure for Details

Step-by-step guide to accessing detailed zonal/point information from operation mode.