Autronica BS-430 User Manual

Service Commands
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 133
14.7.1 Upgrade SW
This menu allows you to upgrade the system software version.
Note that before executing this command, the USB memory stick with
the correct and valid system software file must be inserted into one of
the USB ports. After the stick is inserted, wait at least 5 seconds
before executing the command. To view the upgrade status, the View
Upgrade Status command can be used.
The Reboot System command has to be run after an upgrade of the
system.
Step Actions to be taken Display Indication
1
To enter the Main Menu, press the Menu button
2
To select SERVICE, press 5.
3
To select UPGRADE press 5.
4
To select UPGRADE SW, press 1.
Comments: The message “SW Upgrade in progress” is
shown in the display.
MENU
19:
23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5
SERVICE
SERVICE
19:23
1 TEST
2 LOG
3 LOOP COMMANDS
4 REPORT
5 UPGRADE
6 REMOTE ACCESS
7 DUAL SAFETY
8 OIL & GAS COMMANDS
SERVICE
1 UPGRADE SW
2 UPGRADE CONFIG
3 EXPORT CONFIG
4 EXPORT LOG
5 VIEW UPGRADE STATUS
6 REBOOT SYSTEM
19:23
UPGRADE

Autronica BS-430 Specifications

General

Brand	Autronica
Model	BS-430
Category	Fire Alarms
Language	English