Service Commands
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 141
Step Actions to be taken Display Indication
To transfer the loop control to the Secondary
System, press 2, then
or
to transfer the loop control to the Primary
System, press 1, then .
Dual Safety Stdby
Applicable to systems using the Dual Safety concept; a system with
redundant loop control consisting of a Primary and Secondary System.
Steady yellow light:
The panel is in Standby Mode, i.e. this panel does not control the
detection loops. The panel(s) in the other system controls the detection
loops and is in Active Mode.
Blinking light: the panel does not control all detection loops/loop units,
and/or loop control is being transferred. Actions must be taken.
To Next Page
Loading...
Need help?
General
