15
MADE IN CHINA
11326001001010
15
1. Isolate all sources of electrical supply to the unit including any control system supplies switched by the unit.
Ensure that all points of electrical and gas isolation are secured in the OFF position.
The supply cables and gas pipe work may then be disconnected and removed.
For points of connection refer to unit installation instructions.
2. Remove all refrigerant from each system of the unit into a suitable container using a refrigerant reclaim or recovery unit.
This refrigerant may then be reused, if appropriate, or returned to the manufacturer for disposal.
Under no circumstances should refrigerant be vented to atmosphere Where appropriate, drain the refrigerant oil from each
system into a suitable container and dispose of according to local laws and regulations governing disposal of oily wastes.
3. Packaged units can generally be removed in one piece after disconnection as above.
Any fixing down bolts should be removed and then unit lifted from position using the points provided and equipment of
adequate lifting capacity.
Reference must be made to the unit installation instructions for unit weight and correct methods of lifting.
Note that any residual or spilt refrigerant oil should be mopped up and disposed of as described above.
4. After removal from position the unit parts may be disposed of according to local laws and regulations.
5. Meaning of crossed out wheeled dustbin: Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
Contact your local government for information regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain,
damaging your health and well being. When replacing old appliances with new ones, the retailer is legally obligated to take
back your old appliance for disposals at least free of charge.
This product contains refrigerant under pressure, rotating parts, and electrical connections which may be a danger & cause
injur. All work must only be carried out by competent persons using suitable protective clothing and safety precautions.
DE-COMMISSIONING,DISMANTLING&DISPOSAL
Read the Manual
Risk of Electric Shock
Unit is Remotely controlled
& may start without warning
To Previous Page
Loading...
