AV-GAD EasyLoader AV-2004 - Page 10

10
6
Telephone
then
1
Siren
Address 092 enables ‘Answer Now‘ feature (answers remote computer
after 1 ring). The user attending the control panel can reduce the number of rings before answer to
one ring. To cancel the Answer Now feature hold-down 6 and hold-down 0.
This feature is useful if the control panel was programmed not to answer incoming calls
(programming of 21 rings or greater at address 091). For ‘Answer Now’ to be available, program
01 at address 092.
User should hold-down key 6 and then key 1, before the call is made to the control panel. The
panel will acknowledge the command with two beeps and ‘A.’ is displayed. The feature remains
active for 5 minutes after entered, enabling programmer (at remote computer) to enter the panel.
Test
7
Key 7

FAULT FIND

Fault Find enables testing of all detection devices.

Fault Find mode can be entered only during the 15 seconds following system Disarm.

24H, Fire or Panic alarm will stop Fault Find mode.

Hold down key 7, confirmed by ‘F’ on Keypad display.

Open and close each zone to test. A one-second beep confirms detection of zone opening.
Three beeps indicate zone closing.

Quit Fault Find mode by arming the system.
8
Program
Key 8

PROGRAM
Key 8 accesses ‘Program’ mode and user code programming (changing).
9
Reset
Key 9

RESET
‘Reset’ performs the following functions:
1. Cancels last Keypad entry
2. Stops the communication test (triggered by hold-down key 6)
3. Resets Day Zone Alarm at Keypad
4. Exits Programming mode (features, telephone numbers, etc.), or type 9,9,9 to exit
programming mode (active in LED and PRO panels).
Key ‘0’ Hold-Down functions
1.
0
Shunt
Key 0
Concise Alarm History
: Hold down key ‘0’ to display the last alarm
sequence. New alarm will create a new history instead of the old one.
2.
0
Shunt
and
0
Shunt
Detailed Events History (requires programming):
Hold down key
‘0’ and again hold down key ‘0’ to display up to 36 events, including: System opening and closing
by user number, opening or closing time, zone caused alarm, AC fail.
By holding-down key
0
Shunt
twice
,
three LEDs start blinking to indicate a special operation
mode. The events are being displayed from the most recent to the oldest event.
The event is displayed as following: