12
The local clock time is not stored in system memory; clock must be adjusted after power-up.
System time is reset to 00:00 after power-up, ‘h’ will be displayed to remind user to set time, ‘h’
will be removed after setting new time.
5.
Display and Setting of System Date:
Hold down key ‘0’ and then
hold-down key ‘2’, 3 LEDs are blinking, enter date; ‘dd mm yy’. When history displayed at
keypad, time is displayed. The up and download PC software synchronies time and date.
The local date is stored in system memory; date must be adjusted after long power-fail.
Years 78 through 99 translated as 1978 to 1999
Years 00 through 77 translated as 2000 to 2077
6.
Reset Events Memory:
In program mode press 200 then 04 to erase all events from memory.
7.
Display Last 2 Users:
Hold down key ‘0’ and then hold down key 5
to display user number and System opening or closing time.
‘o’ is displayed for Opening (Disarming); ‘c’ is displayed for Closing (Arming).
8.
(do not hold-down) and press
(do not hold-down), will display ‘-’ to
cancel all Bypassed Zones.
Keys
PANIC BUTTON
Holding down * and # keys will trigger Panic alarm. H will be displayed (zone ‘H’). For Silent
(used with Panic button) Panic alarm, remove siren and buzzer activation by programming the
Panic Zone so. Panic zone program as 24H zone type, N.O. type, fast response type.
To quit zero hold-down functions, hold-down ‘9’
To cancel
Hold-Down
function accessed by keys [0], [6] and [7]; Hold-Down key 9 (Reset)
12. SYSTEM CODES
Up to eight Arm/Disarm codes and one installer (dealer) code are available; each code contains
one to six digits.
Do not use ‘0’ as the first digit in a code.
Do not use ‘5’ as first digit in a code number if Instant Arming via key 5 was program.
The user(s) code must not start with the same numbers as the installer programming code (1994).
Do not use same codes or same first digit for few codes, for example; if code of user one is 1,2,3,4
avoid programming code of user two to be 1,2,5,6.
1.
Default Arming and Disarming Code ‘1 2 3 4’
(Code No. 1) - Use ‘1234’ as Arming
Code (also called Owner Code). Use code No. 1 to program a new user code.
Upon setting new Arming & Disarming code, the default user code ‘1234’ is automatically
replaced. For setting system codes to default, power up by applying AC and battery and
immediately hold-down keys
, after 2
nd
beep release keys, in confirmation
‘U’ blinks 3 times.
2.
Code number 8 as Visitor Code
(requires programming) – Program the Arm/Disarm Code
No. 8 as a ‘one time code,’ for employees and one-time visitors.