24
23. CONTCAT ID FORMAT
For Central Station (CS) reporting two telephone numbers are available, Tel. 2 (address 011) is
main central station Tel. Number and Tel. 3 (address 012) is backup, in case Tel. 2 fails.
Do not program different formats for each telephone.
Contact ID Format (known also as Ademco Express) is the fastest to program and easiest to use
communicator format for central station, with communication speed achieved by the DTMF
signaling.
When using Contact ID format, program only Central Station telephone numbers and the
subscriber ID; all reports will be automatically transmitted, with no need to program anything else.
Step by step:
1. Address 011, 012 enter the central station (CS) telephone numbers
2. Address 201, 202 program 07
3. Address 203, 204 values depends on the CS receiver, ask the CS technical dep’t
4. Address 360, 368, 376 program the subscriber number, the CS will provide this
5. Address 072 –3 determines the opening/closing report status
24. REMOTE UP AND DOWNLOAD
EasyLoad Introduction
The remote up and download feature enables fast and simple programming of EasyLoader panels.
Programming tables, codes and other features may be up & downloaded from an on-site PC (DOS
Mode) via telephone using Modem and ‘EasyLoad’ software, which is supplied separately on a
diskette. The control panel contains a full-duplex modem that conforms to BELL 103 standard.
Installing EasyLoad on your Computer
Insert the EasyLoad diskette in floppy drive A (or B) and type ‘A:’ at the prompter ‘A:>, type
‘AVGAD’. The installation program will guide you, and will install EasyLoad automatically by
making a new directory called AVGAD, or one of your choices. The README 1st file supplied
with EasyLoad will help you operate the up and download program.
To start your EasyLoad: At the prompter ‘C:\AVGAD’ type ‘ESAV’; you will be notified that
some files are missing (the database). Answer ‘Yes’ to create them.
The main EasyLoad menu contains seven selectable fields, to enter main menus use the arrows
(right part of computer keypad) or by entering the field number. Using a mouse is highly
recommended.
The control panel modem is set by default to answer the PC after 10 rings - see address 091,
change address 091 to or higher (21 to 99 rings) in order to disable panel modem. Hold
down key 6 then hold-down key 1 for ‘Answer Now’ mode.
To Next Page
Loading...
