What to do if my AV-GAD EasyLoader AV-2005 keypad displays ‘8,’ but does not react to keys entry?
If your AV-GAD Cell Phone keypad displays ‘8’ but doesn't respond to key presses, it might be due to an incorrect connection of the data wires. To resolve this, check the connections of the Orange and Yellow wires (or the terminal block) at both the keypad and the system wires terminal. Ensure you are using two wires for -V.
What to do if my AV-GAD EasyLoader AV-2005 Cell Phone shows 3 LEDs flashing and '?' is displayed?
If you observe 3 LEDs flashing and a '?' displayed on your AV-GAD Cell Phone, it indicates a power failure. First, connect the AC power and verify that the main socket is functional. If the problem persists, check the transformer.
Why is my AV-GAD Cell Phone keypad failing?
A keypad failure in your AV-GAD Cell Phone could stem from a few potential issues. It may be due to incorrect wiring, in which case you should check the color wire connections. Another possibility is a blown fuse, so verify the power at the panel. Also, check -V with an ohmmeter.
What to do if my AV-GAD EasyLoader AV-2005 Cell Phone displays ‘?‘ (blinking)?
If your AV-GAD Cell Phone is displaying a blinking '?', this indicates that a power failure has occurred. To resolve this, arm and then disarm the device.
What does it mean when my AV-GAD EasyLoader AV-2005 displays ‘H’?
If your AV-GAD Cell Phone displays 'H', it means the panic keys were pressed. To clear this, arm and then disarm the system.
Why is there no siren upon keypad panic on my AV-GAD EasyLoader AV-2005 Cell Phone, but the siren test is OK?
If there's no siren when you trigger a panic alarm on your AV-GAD Cell Phone, even though the siren test works, it's likely due to faulty programming. The panic alarm address should have a value greater than ‘0’ (zero). Refer to address 050.
Why does my AV-GAD EasyLoader AV-2005 keypad display ‘8,’ and keypad sounder is heard?
If your AV-GAD Cell Phone keypad displays ‘8’ and the keypad sounder is audible, it indicates that Zone 8 is troubled. You can resolve this by closing or bypassing zone 8, as it is a 24H-type zone by default.
Why does my AV-GAD EasyLoader AV-2005 Cell Phone keypad display mishmash numbers in a large installation?
If your AV-GAD Cell Phone keypad displays mishmash numbers in a large installation, this is likely due to the wire being too long or too many keypads being wired. To fix this, add a 470 ohm resistor between +12V and the YE terminal in the control panel. Also, use two wires for the –V that supplies power to the keypad.
General| Brand | AV-GAD |
|---|---|
| Model | EasyLoader AV-2005 |
| Category | Cell Phone |
| Language | English |
To Next Page