54
2.11 Verification of Current Programming
(Programmed Values)
Via AV-701/2 Keypad: Set program mode by holding down key
8
Program
and enter programming code
1994, ‘P’ is displayed. Enter address to be verified. The value of this address will be briefly displayed
and three LEDs will blink.
Wait until LEDs stop blinking before verifying next address.
2.12 Remote Up and Download
EasyLoad Introduction (EasyLoad Introduction DOS Version 2.16)
The remote up and download feature enables fast and simple programming of
panels.
Programming tables, codes and other features may be up & downloaded from an onsite PC (DOS Mode,
386 or higher) by using an AV-232 adapter cable, or via telephone using a modem and ‘EasyLoad’
software. ‘EasyLoad’ is compatible with DOS and Windows 95/98.
To program EasyLoader control panel by remote PC, a compatible modem is required. The modem
specifications is critical, before attempting to operate the EasyLoader make sure your modem meets the
following: Supports the Hayes AT command, Bell 103 compatible, DOS mode is selectable.
EasyLoad software supports most modems manufactured after 1994, including: US Robotics, Hayes,
Viva, Boca, Microcom, Netcom Roadster 288, Acer 336, PCMIA 3 com 3CCM156B, Motorola
Lifestyle 28.8, Dataplex Multispeed V.32bis, Netcom Smart modem 56, Acer AME-MU00, ABC 56K
V.90, and other Hayes and Bell 103 compatible modems.
Computers supplied with WINMODEM will not support the EasyLoader.
The control panel contains a full-duplex modem that conforms to BELL 103 standard.
Installing EasyLoad on your Computer
Insert the EasyLoad diskette in the floppy drive A (or B) and type ‘A:’ (or ‘B:’). At prompter ‘A:>‘ type
‘AVGAD217.’ The installation program will guide you, and will install EasyLoad automatically by
creating a new directory on your hard drive, called AVGAD, or a name of your choice.
To start your EasyLoad: at the prompt ‘C:\AVGAD>‘ type ‘ESAV’.
IMPORTANT! The most current updates and EasyLoad features are in the READ ME file.
Read it carefully before using the EasyLoad.
Factory default access code is AVGAD123. Change the code as soon as possible and renew it
periodically.
The first time you run the program, missing “Files Message” displayed (the database), answer ‘Yes’ to
create them.
The main EasyLoad menu contains seven selectable fields. Enter those fields by using the navigation
arrows on your keyboard, or by typing the field number.
Using a mouse is highly recommended. The keyboard can also be used to navigate through the fields,
e.g.
To Next Page