Instructions and user manual ChloriProtect NOT004ENV05
4
3.0 INSTALLATION AND RECOMMENDATION
Install the device in a dry place and well away from sources of heat, and at environmental
temperature not exceeding 40°C.
The device is to be located where flooding cannot occur.
Carefully observe the national wiring rules in force in the various countries as regards of electrical
installations. For Australia and New Zeland, the rules references are in accordance with AS/NZS 3000.
3.1 Installation of the fixing bracket
3.2 Mounting of the clamp
This assembly settles on the pipe, between the filter and the unit of electrolysis. Furthermore, if a regulator
pH is installed, this assembly must be installed upstream to the point of injection of " pH - ".
Next
Drill the top wall of the pipe through the
clamp :
- Ø 14 mm for the probe.
To Next Page
Loading...