Avady POOLeasy pH - REDOX Mode Configuration; MAINTENANCE AND CARE

21
5.2.2 POOLeasy settings in REDOX mode
To set your POOLeasy in REDOX mode, refer to Section (5.0)
Adjustment of the measurement stabilization period (in
minutes) after switching the unit on. Dosing will only
start after this waiting period.
MEASUREMENT TYPE
REDOX
PUMP ACT. TIME
6 s/mV
Setting of pump activation time in
steps of 1 mV, for correction
PUMP FLOWRATE
1.5 L/h
Flowrate setting for pump on the
unit (1.5 or 3 L/h)
OVERDOSING ALARM
0.5 L/4 Hrs
Setting of overdosing alarm: refer to
Section 5.2.4
MEASUREMENT
ADJUST
0 mV
Adjustment of the displayed value by + or – 30 mV.
CAUTION: improper use of this parameter may
result in erroneous dosing.
PUMP FLT INPUT
ON
Allows the enabling/disabling of the 230V input
corresponding to the enabling of the filtration
pump. It is the input that corresponds to cable "i"
defined in Step 13 of the installation procedure.
ACTIVATION TIME
12 min
FACTORY SETTINGS
NO
Allows unit reset.
By selecting YES, a confirmation will follow.
Return to language selection menu.
Press MENU/ESC to exit the menu.