Avady POOLeasy pH - Alarms and Symbols; Alarm Messages and Symbols Reference; Installation and Recommendations; General Installation Recommendations

6
3. Alarms and displayed symbols
Message
Meaning
Action
/ and \ alternatives
The pump is in the process of dosing
Dosing is underway but the pump is
paused. The pause lasts 5 minutes
maximum.
CALIBRATION ERR.
Calibration not possible
- Check state of calibration solution
- Clean the sensor
- Replace the sensor
TANK EMPTY
The reagent tank is empty
LOW MEASUREMENT
pH mode: Measured pH < pH 5
REDOX mode: measurement <
100 mV
Check pool water parameters
TAC > 100 mg/L
HIGH MEASUREMENT
pH mode: Measured pH > pH 9
REDOX mode: measurement >
900 mV
Check pool water parameters
TAC > 100 mg/L
FILTR. DISABLED
The filtration pump is not operating.
The POOLeasy unit is therefore
paused.
Refer to Section 5.2.1 to disable filtration
pump input if you do not want the
POOLeasy unit to pause when the filtration
pump stops.
OVERDOSING ALARM
The POOLeasy unit has dosed more
than the threshold defined in the
settings.
Refer to Section 5.2.4
4. Installation and recommendations
4.1 Recommendations
 It is essential that the pump be installed far from a source of heat, in a dry place with a
maximum ambient temperature of 40°C.
 Comply with the country's applicable standards with regard to electrical installations.