21
Replacing the Filters
6. Insert the probe assembly back into
the bottle. Slide the collar down until it
clicks into place. Push the head down
until the tube hits the bottom of the
bottle.
7. Slide the bottle into the cabinet.
8. After replacing the filters, press
the Filter Reset Button (#13) 3 times
consecutively, and close the door.
9. In order to flush the new filters, allow
the water to flow from the water spout
(#10) for approximately 2 minutes.
3x
collar
head
2 min
Replace Filters
User Guide and Maintenance
English
To Next Page
Loading...
