AVANT 630 - User Manual

Questions and Answers

A
alexandrialesterJul 27, 2025
Why AVANT Compact Loader engine won't crank?
- N
  Nicholas JonesJul 27, 2025
  If your AVANT Compact Loader engine won't crank, it could be due to several reasons: the main switch might be off (turn it on), the battery could be discharged (check and charge it), a fuse might be blown (check fuses and contact service if it blows again), or the battery cables may be poorly connected (check, clean, and retighten them if necessary).
R
rogersjohnnyAug 2, 2025
What to do if AVANT 630 Compact Loader engine cranks but doesn't start?
- H
  hlarsonAug 3, 2025
  If your AVANT Compact Loader's engine cranks but doesn't start, consider these possibilities: * Check if you have the correct type of fuel and enough of it. * Ensure the engine is getting fuel; the fuel filter or fuel line may be clogged. * If it's cold, hold the ignition key in the glow position longer, and extend starting time up to 5 seconds. * Make sure the auxiliary hydraulics control lever is in the center (neutral) position. * The battery could be discharged or damaged; jump start it or replace it if necessary.
J
James SanchezAug 8, 2025
How to fix AVANT 630 Compact Loader engine overheating?
- M
  Melissa CantuAug 8, 2025
  To fix an overheating AVANT Compact Loader engine: * Clean the radiator and fan from the engine side. * Add coolant if the coolant level is low. * Check the coolant pressure reservoir cap for tightness and inspect the cooling system, hoses, and connections for leaks.
M
Mark GarciaAug 14, 2025
Why is the hydraulic system overheating on my AVANT 630?
- A
  Adam NealAug 14, 2025
  An overheating hydraulic system in your AVANT Compact Loader can be caused by: * Low hydraulic oil level (check and refill). * A clogged oil cooler (clean the cooler and fan). * A faulty fan (check, clean, and repair if necessary). * Restricted hydraulic oil flow (ensure the auxiliary hydraulics valve is completely opened when using high flow attachments and adjust the lever locking plate if necessary). * An overloaded hydraulic system (use the attachment at a lower engine rpm, use with 1-pump setting, and check the attachment for faults).
G
Gary HortonAug 21, 2025
What to do if AVANT 630 Compact Loader doesn't move after releasing the parking brake?
- D
  David MurrayAug 21, 2025
  If your AVANT Compact Loader doesn't move after releasing the parking brake, it could be due to: * A bad connection on the wiring of the parking brake switch, a blown fuse, or a faulty switch (check wires, fuse, and switch, repair if necessary. Contact service). * Low hydraulic charge pressure (contact service for pressure check). * A faulty solenoid valve (check and replace if possible. Contact service).