8 (40)
WARNING
Always transport the mower as low and as close to the machine as possible to keep
the centre of gravity low. On slippery surfaces drive slowly and deliberately. Operate
the controls of the loader slowly and calmly especially on inclined terrain.
Use the attachment only for its intended use and only with original tools and spare
parts.
Shut down the loader and place the attachment to a safe position as shown in Safe
stopping procedure before any cleaning, maintenance, or adjustments.
Pay attention to the surroundings and any other persons and machines moving in the
vicinity. Pay attention to the contours of the terrain and other hazards, such as
branches and trees that can reach to the driver's area, loose rocks, and slippery
surfaces.
Make sure to use only an attachment that is in good condition. Do not modify the
attachment in any way that could affect its safety.
Use the equipment only for its intended purpose. Other use may create unnecessary
safety risks, and the equipment may get damaged.
Make sure that the loader is equipped with necessary safety components, and that
they are in working condition. Seat belt must be used. If there are specific hazards
related to the operating area, use appropriate safety equipment.
Stop the loader engine and release any residual pressure before adjustments or
maintenance work.
Also read the safety instructions and correct use of the loader from the operator's
manual of the loader.
DANGER
Wrong, improper, or careless use of the attachment causes serious risk of severe
injuries or death.
Familiarise yourself with the controls of the loader in a safe area. Pay
particular attention to the safe stopping of the attachment and the loader; follow the safe
stopping procedure shown in this manual before leaving the driver's seat.
DANGER
Risk of entanglement and crushing -
Stop the attachment before cleaning or
removing blockages.
The attachment can start to rotate immediately after a blockage is
removed. Always follow the safe stopping procedure to prevent all rotating parts from
moving when clearing a blockage.
DANGER
Risk of cutting and severing -
points on work tools.
Beware of the sharp blades and risk
of crushing especially during maintenance or when removing
blockages. Always stop the attachment by following the safe
stopping procedure. To make sure that the attachment will
not rotate, disconnect the multiconnector (or hydraulic quick
couplings) before going near it. Note that the loader boom
moves down and may be tilted even if the engine has been
stopped. Never go under a raised boom or any component of
the attachment. Keep away from the moving linkage.
To Next Page
Loading...
