33 (40)
Using the auxiliary cooler with Opticontrol® system:
1.
OFF
Switch the Opticontrol
®
Auto-
PTO mode switch to position OFF on the loader (if
equipped).
2.
The cooler is controlled as follows:
1
Push the button to position 1 to start the cooler, and to position 0 to stop
the cooler.
2 Not in use with this attachment
3 Not in use with this attachment
Using the auxiliary cooler with separate switch:
Keep the separate 2-
position switch in the cab in location where it is easily
accessible, but will not interfere with other controls, and will not be used
inadvertently.
Turn the switch to start and stop the cooler.
6.13 Storing the attachment
Uncouple and store the attachment on level surface so, that it will stand firmly on its skids. The best storage
place for the attachment is a place where it is protected from rain and direct sunlight.
Avoid storing the attachment directly
against the ground, place a pallet or
blocks of wood under it, for example.
Place the multiconnector on to its
holder as indicated with an arrow in the
adjacent figure. Never leave the
hydraulic connector on the ground.
Ensure the stability of the attachment
during its storage.
Never climb on the attachment.
Before long storage period, carefully clean the cutting deck and the mower components, removing all
remaining clippings. Touch up the paint where needed and grease the lubrication points to prevent rust
damage.
To Next Page
Loading...
