6
User Manual
www.AvantcoRefrigeration.com
SS Series Reach-In Refrigerators and Freezers
Defrost System
Automatic Defrost Cycle
•
Refrigerator coils are kept below the freezing point (32 degrees Fahrenheit).
•
During compressor downtime, the evaporator fan continues to circulate air through the
evaporator coil. This air circulation raises the coil temperature above the freezing point, melting
any accumulated frost.
•
Run-o water is drained into the evaporator pan and evaporated.
•
Freezer coils are defrosted electronically.
•
Automatic defrost timers initiate at pre-set intervals and for a predetermined duration.
Running a Manual Defrost Cycle
Units are preprogrammed to run automatic defrost cycles at preset intervals. However, if you
would like to run a manual defrost cycle at any time, follow the steps below:
Refrigerators:
Press the defrost button ("DEF" and ) for approximately 5 seconds. Repeat to
stop the defrost cycle.
Freezers:
Press the defrost button (snowflake symbol and ) for approximately 3 seconds. Repeat
to stop the defrost cycle.
Safety & Warning
Pay close attention to the safety notices in this section. Disregarding these notices may lead to
serious injury and/or damage to the unit.
Attention
•
To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet
for your unit.
•
Do not use extension cords.
•
Do not put your hands under the unit while it is being moved.
•
When the unit is not in use for a long period of time, please unplug the unit from the outlet.
•
After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so
could cause damage to the compressor.
Unplug Cord
•
To minimize shock and fire hazards, please do not plug or unplug the cord with wet hands.
•
During maintenance and cleaning, please unplug the unit.
Proper Grounding Required
•
To minimize shock and fire hazards, make sure that the unit is properly grounded.
To Next Page
Loading...
