EasyManua.ls Logo

Avanti CIM102U3S - User Manual

Avanti CIM102U3S
68 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
Model / Modelo / Modelé: CIM102U3S
COMMERCIAL ICE MAKER
MAQUINA DE HACER HIELO
COMERCIAL
MACHINE A GLAÇONS
COMMERCIALE
INSTRUCTION MANUAL
MANUAL DE INSTRUCCIONES
MANUEL D’INSTRUCTIONS
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING
INSTRUCTIONS.
Avanti has a policy of continuous improvement on its products and reserves
the right to change materials and specifications without notice.
Avanti Products LLC
P.O. Box 520604
Miami, FL 33152
www.avantiproducts.com

Table of Contents

Questions and Answers

  • D
    Danielle UnderwoodAug 16, 2025
    Why my Avanti CIM102U3S doesn't operate?
    • C
      Casey SmithAug 16, 2025
      If your Avanti Ice Maker isn't turning on, there are several potential causes. First, ensure the ice maker is properly plugged into the power outlet. Second, check the fuse and replace it if it's blown; if it blows again, have a service technician check for a short circuit. Also, verify that the power button is switched to the 'ON' position. Lastly, if the ice storage bin is full, remove some ice to free the ice-full probe.
  • Q
    qcastilloAug 19, 2025
    What to do if Avanti CIM102U3S is leaking water?
    • M
      Michael MayAug 19, 2025
      If you notice water leaking from your Avanti Ice Maker, here are a few things to check: * Some water falling to the floor when opening the door to remove ice is normal condensation. Take care when removing ice. * If the water supply connection is leaking, try tightening the fitting. * Ensure the drain pipe is lower than the drain outlet to facilitate proper drainage.
  • R
    Renee CraigAug 22, 2025
    Why does my Avanti CIM102U3S Ice Maker stop while making ice?
    • V
      Veronica HooperAug 22, 2025
      If your Avanti Ice Maker suddenly stops during operation, consider these possibilities: * Ensure that the electricity supply is connected. * If the room temperature is outside the specified range, disconnect the ice maker and wait until the temperature returns to normal. * If the ice storage bin is full, remove some ice and make sure the ice-full probe is free of ice.
  • J
    Jamie Moreno PhDAug 26, 2025
    Why Avanti CIM102U3S Ice Maker makes ice but does not fill up with ice?
    • M
      Mark SanchezAug 26, 2025
      If your Avanti Ice Maker is producing ice, but the bin isn't filling up, consider these possible causes: 1. The condenser may be dirty, so try cleaning it. 2. The airflow to the ice maker might be obstructed; check the installation. 3. High ambient and water temperatures, or proximity to a heat source, can also affect ice production; check the installation.
  • T
    Tammy HillAug 28, 2025
    What to do if water doesn't feed in Avanti CIM102U3S?
    • W
      William FloresAug 28, 2025
      If water isn't feeding into your Avanti Ice Maker after it starts, check that the water supply tap is turned on. Also, make sure the water supply pipe is properly connected.
  • L
    Lisa RothAug 31, 2025
    How to fix water leaks from Avanti CIM102U3S storage bin?
    • W
      William ThompsonAug 31, 2025
      If water is leaking from the ice storage bin of your Avanti Ice Maker, check if the drainhole below the ice storage bin is blocked and clean it if necessary. Also, inspect the drain hose to ensure it is not kinked or positioned higher than the floor of the ice storage bin, which could prevent proper drainage.
  • G
    George Robinson DDSSep 3, 2025
    How to prevent scaling in Avanti Ice Maker?
    • A
      Andrew VazquezSep 3, 2025
      If scaling occurs frequently inside your Avanti Ice Maker, it may be due to high water hardness. Consider installing a water-softening device in front of the water inlet.
  • A
    Angela WalkerSep 6, 2025
    Why Avanti CIM102U3S cubes are partially formed?
    • S
      Steven PhillipsSep 6, 2025
      If the ice cubes from your Avanti Ice Maker are partially formed or have a white bottom, first check if the water supply pressure is below 15 psig. Additionally, inspect the water supply or filter for any restrictions, and check for any water leaks at the water trough.
  • H
    Harry BryantSep 9, 2025
    Why my Avanti Ice Maker is making noise?
    • W
      williamkramerSep 9, 2025
      If your Avanti Ice Maker is making unusual noises during operation, ensure that the feet are leveled and locked properly. Also, be aware that certain sounds are normal during operation.
  • J
    Jessica Kim DDSSep 12, 2025
    What to do if Avanti CIM102U3S body is electrified?
    • L
      Lance CruzSep 12, 2025
      If the body of your Avanti Ice Maker is electrified, use a socket meeting the grounding requirements.

Avanti CIM102U3S Specifications

General IconGeneral
TypePortable Ice Maker
Ice Storage Capacity1.5 lbs
Ice SizeSmall, Medium, Large
Water Reservoir Capacity2.2 liters
Voltage115V / 60Hz
Ice Production Capacity26 lbs per day
Power Consumption120 watts
Ice TypeBullet
Ice Making Cycle6-12 minutes

Related product manuals