OPERATING YOUR ICE MAKER
Control Panel Description
CUBE SIZE INDICATOR LIGHTS
WATER SHORTAGE INDICATOR
LIGHT
CUBE SIZE SELECTOR BUTTON
Ice Size
ICE SIZE SELECTION of (S) small or (L) large.
The default cube size from the factory is set at LARGE.
Each time you press this button the cube size selection will change between Small and Large.
The chosen mode shall stay as selected unless changed or there is a power failure.
For the most efficient operation when ambient temperature is below 15°C (59ºF) use the small
cube size setting.
LED INDICATORS
POWER INDICATOR (GREEN)
The indicator above the word POWER will illuminate green when the unit is turned on.
ICE SIZE INDICATOR (GREEN) (S) small or (L) large.
The indicator above the selected cube size will be illuminated green.
ADD WATER INDICATOR (RED).
The ice maker automatically checks the water level in the tank. If the water level is too low the
indicator will illuminate in RED and will stop working automatically. Once you add water to the unit
the indicator will turn off and will resume normal operation.
ICE FULL INDICATOR (RED).
When the ice-bin is full, the indicator will illuminate in RED. The indicator will remain lit until the ice
in the bin either melts away slowly or has been removed. The unit will stay in a “Standby” mode
until the ice has been removed / melted at which time the unit will automatically start operation as
normal.
To Next Page
Loading...
Need help?
General
