Avantree EON - Subsequent Connections

9
EONUser Manual
EN
For subsequent use, your headphones should automatically reconnect to the
last-paired device within a few seconds of being turned on. If not, you
can manually activate reconnection by sliding the switch to “HOLD TO
PAIR” once, or by selecting "Avantree Eon" in your device's Bluetooth menu.
OFF/
Wired
ON
Hold
to Pair
STEP 3
Keep the headphones close to your device and wait for 5-10 seconds or until
they connect. Once they're successfully connected, the headphones' LED
indicator will ash blue, and you’ll hear a “CONNECTED” voice indicator.
Accessory
Accessory
Avantree Eon
MY DEVICES
OFF/
Wired
ON
Hold
to Pair
“Connected”