Avanzini DRAGO SIX+ - Nd FLAME (F2)

CHAPTER 6
Instructions, use and maintenance manual
Page 71
DRAGO SIX+
6.2.6. GAS ADJUSTMENT 2
nd
FLAME (F2)
CAUTION!
2
nd
ame (F2) gas adjustment is performed directly from the operator panel.
The 2
nd
ame F2 us designed to heat the oven and cook bread and/or pizza.
The adjustment criteria of F2 are:
• ame length: the tip of the ame reaches at least the centre of the oven cupola (goes beyond 10/15cm).
• gradient of T°: 100°-120°C/hour
After adjusting the 1
st
ame F1 and turning on the 2
nd
ame F2:
STEP ACTION IMAGE
1
Press the "C" key to increase the temperature to be set.
Then the F2 LED turns on.
C
To obtain the right ame, i.e. whose tip reaches the centre of the cupola of the oven and which brings a T°
increase of 100°C-120°C per hour, check that the burner Drago Six, according to the size of the oven, mounts
the nozzles for the 2
nd
ame F2, indicated in the table on the following page.