Avaya 4000 Series - Stack health check; Stack Forced Mode

Avaya Inc. – External Distribution
IP Office & Ethernet Switching Technical Configuration Guide
29
avaya.com
October 2012
Use the following commands to configure ADAC LLDP auto-detection mode:
1
Enable LLDP ADAC auto-detection on each IP telephony port:
IPO4526GTX(config)#adac detection port <portlist> lldp
2
Disable ADAC MAC auto-detection. If it is globally enabled, disable it:
IPO4526GTX(config-if)# no adac detection port <portlist> mac
3
Globally configure tagged frames mode on the switches:
IPO4526GTX(config-if)#adac op-mode tagged-frames
7.2.3 Configuring PoE
Use the following commands to enable PoE on one or all ports and to verify your configuration. This
section also includes the commands to disable PoE in case you have to remove or replace a device.

Note – PoE is enabled by default on the ERS 2000, ERS 3000, ERS 4000, and ERS 5000
Series.
1
Enable PoE on a specific port:
IPO4526GTX#configure terminal
IPO4526GTX(config)#interface fastEthernet 1
IPO4526GTX(config-if)#no poe-shutdown
2
Enable PoE on all ports:
IPO4526GTX(config)#interface fastEthernet all
IPO4526GTX(config-if)#no poe-shutdown
3
Disable PoE on a specific port:
IPO4526GTX(config)#interface fastEthernet 1
IPO4526GTX(config-if)#poe poe-shutdown
4
Disable PoE on all ports:
IPO4526GTX(config)# interface fastEthernet all
IPO4526GTX(config-if)#poe poe-shutdown