The part number for this model is AA1419043-E6.
The maximum current requirement of the SFP is 375 milliamperes (mA) at 5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 2: IEEE 802.3z 1000BASE-T SFP specifications
Parameter Specifications
Standards IEEE 802.3z, IEEE 802.3ab
Connectors RJ-45
Cabling CAT5E or better UTP
Distance Up to 100 m
100BASE-FX SFP specifications
The 100BASE-FX SFP provides 100 Mbps Ethernet Carrier Sense Multiple Access with Collision
Detection (CSMA-CD) connectivity using multimode optical fiber. The part number for this model is
AA1419074-E6.
The following table describes the 100BASE-FX SFP specifications.
Table 3: 100BASE-FX SFP specifications
Parameter Specifications
Maximum electrical power consumption 1.5 W
Connectors Duplex LC
Cabling • 62.5 µm MMF optic cable
• 50 µm MMF optic cable
Distance • Up to 2 km using 500 MHz-km MMF optic cable
Wavelength 1310 nm
Link optical power budget 10 dB
Transmitter characteristics
Maximum launch power –14 dBm
Minimum launch power –23.5 to –20 dBm
Receiver characteristics
Receiver sensitivity –33.5 dBm
Maximum input power —
1000BASE-SX (LC) SFP specifications
The 1000BASE-SX SFP transceiver provides 1000BASE-SX gigabit Ethernet connectivity at 850 nm
using multimode optical fiber. This SFP supports only full-duplex operation. The part number is
AA1419013-E5*.
SFP specifications
July 2015 Installing Transceivers and Optical Components on Avaya ERS 3500 Series 25
Comments on this document? infodev@avaya.com
To Next Page
Loading...
