Warning:
Risk of equipment damage
To prevent damage to the optical receiver, ensure that at least 5 dB of attenuation exists
between the transmit and receive ports.
Table 12: 1000BASE-ZX DDI 1550 nm SFP transceiver specifications
Parameter Specification
Maximum electrical power consumption 1.0 W
Connectors Duplex LC
Cabling SMF, 9 μm
Data rate 1.0 Gbps
Line rate (8B/10B code) 1.25 Gbps
Link optical power budget 24 dB
Maximum dispersion power penalty 2 dB at 70 km
Minimum attenuation between transmit and receive
ports
5 dB
Transmitter characteristics
Launch power 0 to 5 dBm
Receiver characteristics
Receiver sensitivity –24 dBm
Maximum receiver power –0 dBm
1000BASE-BX bidirectional SFP transceivers
The 1000BASE-BX bidirectional DDI SFP transceivers provides gigabit Ethernet connectivity over a
single fiber.
Warning:
Risk of equipment damage
For the 40 km transceivers only. Connect the 1000BASE-BX SFP transceiver using a single
mode fiber with at least 6 dB of attenuation. Damage can result if insufficient attenuation is
provided or if the same 1000BASE-BX SFP transceivers are connected.
In the following figure, the transmit (Tx) and receive (Rx) paths share the same fiber by using two
different wavelengths. One model transmits at 1310 nm and receives at 1490 nm, while the mating
model transmits at 1490 nm and receives at 1310 nm. You can only connect a mating pair.
SFP specifications
July 2015 Installing Transceivers and Optical Components on Avaya ERS 3500 Series 31
Comments on this document? infodev@avaya.com
To Next Page
Loading...
