Avaya S8300 - Chapter 2: Converting an S8300 from LSP to ICC and upgrading Communication Manager from 1.x to 2.x

17
Note: Complete this step only if you are connecting more than one G700
Media Gateway in a stack configuration.
1
Using the gray X330SC short cables,
connect the media gateways from the
bottom up:
• Connect the light gray connector to the
port labeled “Cable to upper unit.”
• Connect the dark gray connector to the
port labeled “Cable to lower unit.”
• Repeat both steps until all units in the
stack are connected (maximum of 10
units).
2
For single stack redundancy, connect the
bottom unit and the top unit using the
black X330RC redundancy cable:
• Connect the light gray connector to the
port labeled “Cable to upper unit: on
the top unit of the stack.
• Connect the dark gray connector to the
port labeled “Cable to lower unit” on
the bottom unit of the stack.
5 Connect Media Gateways