What to do if the yellow LED flashes on Avaya Server after powering up?
If the yellow LED flashes after powering up the Avaya Server cabinet, this indicates a power fault. Refer to 'Troubleshooting power units' for detailed instructions.
Why is the 1217A yellow power supply LED not lit on my Avaya Definity SI Server?
If the 1217A yellow power supply LED on your Avaya Server is not lit, it is likely faulted due to overload conditions. Note that the power supply continues to provide other output voltages (±5V DC and -48 V DC) to circuit packs and does not completely shut down as earlier power supplies do if the +12V fan or the +12V DC tape drive outputs are overloaded.
What to do if none of the control or port circuit packs appears to be defective in Avaya Server?
If you've ruled out defective control or port circuit packs on your Avaya Server, check the cabinet temperature.
What to do if the yellow LED on the suspect power supply does not light immediately on Avaya Definity SI Server?
If the yellow LED on the suspect power supply of your Avaya Server does not light immediately, unseat the control circuit packs one at a time while observing the LED on the power supply.
What to do if the yellow LED on the power supply does not light during the reseating of the control circuit packs in Avaya Server?
If the yellow LED on the power supply of your Avaya Server does not light during the reseating of the control circuit packs, unseat all port circuit packs.
What to do if circuit packs and cabinet temperature are not the cause of the problem in Avaya Definity SI Server?
If you've eliminated both the circuit packs and the ambient cabinet temperature as potential causes for the issue with your Avaya Server, replace the power unit.
General| Model | Definity SI |
|---|---|
| Type | PBX Server |
| Protocols Supported | Analog, Digital |
| Trunk types supported | Analog |
| Expansion | Modular expansion |
| Power Supply | Redundant power supply option |
To Next Page
