Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-428 Issue 4 May 2002
test data-module
This command performs hardware diagnostic tests on a data module or data
channel. Test results are determined by the interface to the digital switch-data line
port, digital line port, or network control data channel.
!
WARNING:
Since the “clear long” options clear all counters if tests pass, it is possible for
firmware counters to be cleared even when a problem exists. In some cases
customer service might degrade since calls may be routed over defective
equipment.
Action/
Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
test
data-module
extension
short
long
repeat
number
clear
schedule
Extension of the data module or
data channel to be tested (per
dial-plan)
Option for a brief series of
nondestructive diagnostic tests.
Option for a longer, more
comprehensive test series
(includes a destructive test)
How many times each test in the
sequence is repeated (1-100)
This option causes the test
sequence (short or long) to repeat
until the alarm (if any) is cleared or
a single test in the sequence fails.
1
Command is validated and then a
scheduling form displays to
schedule execution of the
command. The command is then
placed in the command queue and
is executed at the specified time.
The information displayed by the
command is sent to the system
printer instead of the screen.
2
Examples:
test data-module 30000 l
test data-module 30000
test data-module 32000 sh r 2
test data-module 33000 l r 25
test data-module 33000 l r 25
schedule
test data-module 30000 c
1 If no alarms are registered against the maintenance object then the test sequence is run only once. The long
clear option forces a clear of all alarms if no errors are encountered during testing. The short clear option only
clears alarms pertinent to tests in the short sequence. SEE WARNING BELOW.
2 Refer to the Report Scheduler and System Printer feature specification for more details.
init
inads
craft
cust
nms
Test
sequence
= short;
repeat = 1
none
To Next Page
Loading...
