test inads-link
Issue 4 May 2002
A-127 555-233-123
test inads-link
Help Messages
If the system technician presses HELP after entering “test inads-link” the following
message appears:
[‘1’ or ‘2’]
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
test interface
Help Messages
If the system technician presses HELP after entering “test interface” the following
message appears:
Enter [cabinet(1)];carrier(A-B), pos(1-2),
[’long’ or ’short’], [’repeat’ (1-100)
or ’clear’], [’schedule’]
Error Messages
If the specified carrier is not the active PE, the following message appears:
Command must be executed from active SPE
If the technician-entered cabinet and carrier is invalid for a PPN, the following
message appears:
Invalid port-network specified
If the technician-entered carrier is not a valid carrier, the following message
appears:
Invalid carrier specified
To Next Page
Loading...
