Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-12 Issue 4 May 2002
Field descriptions
busyout packet-control
This command places the packet-control circuit pack in a maintenance busy state,
and tears down each point-to-point signaling link that terminates on this
packet-control. No periodic or scheduled test is performed on the busied out
packet-control until it is released. A warning alarm (error type 18) is generated on
the busied out packet-control, so that INADS can determine the state of the
object. The release packet-control command reactivates the board and initiates
recovery on all point-to-point signaling links terminated on this packet-control.
Feature Interactions
■ In a duplicated system, the packet-control busyout of standby process
complex is not allowed.
■ When the packet-control in the active control complex is busied out, all
connectivity across the Packet Bus is severed. Thus, all ISDN-BRI
point-to-point signaling links that have been established through the active
packet-control are torn down by the busyout packet-control command.
The release packet-control command re-establishes all Packet Bus
connectivity.
Port
Port address (cabinet-carrier-slot-circuit)
Maintenance Name
Name of busied out maintenance object: MODEM-PT
Alt. Name
Not applicable
Result
Test result: Pass, Abort, Fail
Error Code
Numeric code explaining why the release failed or aborted.
Refer to the detailed list of codes by test number for each MO.
Action/
Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
busyout
packet-
control
location Applies to duplicated
configurations only - a
carrier that contains
packet-control in the
system. Valid locations =
1A or 1B.
Examples
busyout packet-control
1A
busyout packet-control
1B
init
inads
craft
simplex
systems
(optional) =
cabinet 1,
carrier A
duplex
systems =
cabinet 1,
carrier of
choice.
See below
To Next Page
Loading...
