Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-8 Issue 4 May 2002
busyout packet-control
Help Messages
If the system technician presses HELP after entering “busyout packet-control,” the
following message appears:
Enter Packet Control location: [cabinet(1)];carrier(A-B)
Error Messages
If this command is entered for a packet-control that resides on the stand-by
control complex of a duplicated system, the following message appears:
Command only applies to the active Packet Control
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
busyout pms-link
Help Messages
If the system technician presses HELP after entering “busyout pms-link” the
following message appears:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
