enable mst
Issue 4 May 2002
A-49 555-233-123
If the connection number entered is not administered, the following message
appears:
Identifier not assigned
If the administered connection number entered is already enabled, the following
message appears:
Administered connection already enabled
If the software data cannot be sent to the SAT, the following message appears:
Error encountered, can’t complete request
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear and then resubmit
enable mst
Help Messages
If you press Help after entering “enable mst”, the following message displays:
Entry is not required
Error Messages
If the command conflicts with another currently executing command, a message
displays the login ID of the conflicting user and the conflicting command.
’login id’:’command’ has a command conflict
enable suspend-alm-orig
Help Messages
Enter board or port location,
[‘off-board-only’], expires-in-hrs(1-72)
To Next Page
Loading...
