disable firmware download
Issue 4 May 2002
8-51555-233-123
disable firmware download
disable firmware download
This command stops the current firmware download. If a target board is currently
downloading the download is first completed for the current board but the
remaining boards are not downloaded.
disable mst
This command stops the message trace facility. If the trace was not already
disabled, the command inserts a GAP marker into the trace. The user should
execute the disable mst command when the trace is complete. If left enabled, the
trace continues to use CPU time until the time limit expires. Entering disable mst
command has no effect on the system if the trace is already disabled. To view the
results of the trace, enter the list mst command.
disable suspend-alm-orig
This command stops entries from the active Suspend Alarm Origination table and
disables all board entries that match a specific physical board location.
NOTE:
This command does not disable port entries.
Action/
Object Qualifier
Qualifier
Description Logins Defaults
Feature
Interactions
disable mst Example:
disable mat
init
inads
none none
Action/
Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
disable
suspend-
alm-orig
board
location
Physical location of the
replaced or corrected board
(does not support port
location): PCss
Examples:
disable suspend-alm-orig
1C03
disable suspend-alm-orig
1E07
init
inads
craft
cust
rcust
none none
To Next Page
Loading...
