release pri-endpoint
Issue 4 May 2002
A-69 555-233-123
If the board on which the port resides is part of the SCI link, the following error
message appears:
Cannot busyout/release part of SCI link
If the port is translated within a Wideband Access Endpoint, the following error
message appears:
Port within wideband access endpt;
Use busyout access-endpoint <ext> instead
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
release pri-endpoint
Help Messages
If the user presses HELP after entering “release pri-endpoint,” the following
message appears:
Enter assigned extension
Error Messages
If the format for the extension is incorrect, the following error message appears:
Extension invalid
If the EPN on which the PRI endpoint resides is not accessible, the following
message appears:
EPN is not available
If the extension is not administered, the following message appears:
Extension not assigned
To Next Page
Loading...
