recycle carrier
Issue 4 May 2002
A-59 555-233-123
Error Messages
If the format of the trunk identifier is incorrect, the following error message
appears:
Format invalid
If the trunk identifier is not in the valid range, the following error message appears:
Trunk or trunk group invalid
If the trunk group member is not administered, the following message appears:
Group member not assigned
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
recycle carrier
Help Messages
If the system technician presses HELP after entering “recycle carrier” on a
simplex SPE system, the following message appears:
Enter [cabinet(1-3)];carrier(B-E)
If the system technician presses HELP after entering “recycle carrier” on a duplex
SPE system, the following message appears:
For cabinet 1 enter [cabinet(1)];carrier(C-E)
For cabinet 2-3 enter cabinet (2-3);carrier(B-E)
Error Messages
If no location is entered, the following message appears:
Identifier command word(s) omitted; please press help
If a location greater than three characters is entered, the following message
appears:
Entry invalid
If the location entered is longer than 3 characters or less than 1 character the
following appears:
Invalid carrier specified
To Next Page
Loading...
