ALARM-PT (ALARM PORT)
Issue 4 May 2002
10-43 555-233-123
ALARM-PT (ALARM PORT)
The Alarm Port Maintenance Object provides on-board maintenance for an
analog line port that is administered as an external device alarm port. Tests are
provided to verify the analog line port’s ability to detect an external device alarm.
The External Device Alarm (EXT-DEV) Maintenance Object is used for the
off-board external device alarm.
MO Name (in
Alarm Log)
Alarm
Level
Initial Command to
Run
1
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the
carrier designation (for example, A, B, C, D, or E); SS is the address of the slot in
the carrier where the circuit pack is located (for example, 01, 02,...,etc.); and pp
is the 2-digit port number (for example, 01).
Full Name of MO
ALARM-PT MIN test port PCSSpp l Alarm-Port
ALARM-PT WRN test port PCSSpp sh Alarm-Port
To Next Page
Loading...
