Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-76 Issue 4 May 2002
If a board is not inserted in the specified location, then the following message
appears:
Board not assigned
If the specified board is active, the following message appears:
Illegal command for active object;
use ’set’ to switch to standby
If a reset is attempted on an invalid board in the service slot, the following
message appears:
Board invalid
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
reset interface
Help Messages
If you press HELP after entering “reset interface,” the following message displays:
Enter identifier: [cabinet(1)];carrier(A-B);position(1-2)
Error Messages
If the specified carrier is not the active PE, the following message appears:
Command must be executed from active SPE
If the technician-entered cabinet and carrier is invalid for a PPN, the following
message appears:
Invalid port-network specified
To Next Page
Loading...
