copy update-file
Issue 4 May 2002
A-33 555-233-123
Error Messages
If the port is not administered, the following error message appears:
Port not marked
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
copy update-file
Help Messages
If the system technician presses HELP after entering “copy update-file” on a duplex
SPE system the following message appears:
[’override’]
Error Messages
If the standby SPE contains a newer patch file than the active SPE and the
override option was NOT used, the following message appears:
Active SPE’s update file is older than standby’s
If the vintage of the standby SPE doesn’t match the vintage of the active SPE, the
following message appears:
Update file vintage does not match standby SPE core vintage
If there is no update file on active processor, the following message appears:
No update file on tape
If the standby SPE is NOT in standby mode, the following message appears:
Cannot access the standby SPE at this time
If the active SPE cannot establish a communication path to the standby SPE, the
following message appears:
Could not establish netcon data call between SPE’s
To Next Page
Loading...
