busyout sp-link
Issue 4 May 2002
A-11 555-233-123
busyout sp-link
Help Messages
If the system technician presses HELP after entering “busyout sp-link,” the
following appears:
Entry is not required
Error Messages
If the system printer link is not administered, the following message appears:
Link not administered or not enabled
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
busyout spe-standby
Help Messages
If the system technician presses HELP after entering “busyout spe-standby” the
following message appears:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If this command is issued while an upgrade software command is active the
following message appears:
Standby SPE upgrade in progress, command denied
To Next Page
Loading...
