Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-144 Issue 4 May 2002
test sp-link
Help Messages
If the system technician presses HELP after entering “test sp-link”, the following
appears:
Enter [’long’ or ’short’], [’schedule’]
Error Messages
If the system printer link is not administered, the following message appears:
Link not administered or not enabled
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
test spe-standby
Help Messages
If the system technician presses HELP after entering “test spe-standby” the
following message appears:
Enter [’long’ or ’short’],
[’repeat’ (1-100) or ’clear’], [’schedule’]
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If the standby is entering maintenance mode when this command is executed,
then the following message appears:
Cannot interrupt Standby SPE while entering
maintenance mode; please try later
To Next Page
Loading...
