Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-66 Issue 4 May 2002
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
release modem-pool
Help Messages
If the system technician presses HELP after entering “release modem-pool” the
following message appears:
Enter assigned group number between 1-5
Or press CANCEL to cancel the command
Error Messages
If the “release modem-pool” command is entered from a login for which the
command is not valid, then the following message appears:
“release” is an invalid entry; please press HELP
If the group or member numbers entered are not in a valid format, the following
message appears:
Identifier invalid
If the group number entered is not within the range of groups or the member
number is not within the member range, then the following message appears:
Boards not assigned
If the specific group or member are not administered, then the following message
appears:
Group not assigned, or group assigned but with no member
If a software fault is encountered while the command is executing, the following
message appears:
Error encountered, can’t complete request
To Next Page
Loading...
