display initcauses
Issue 4 May 2002
A-43 555-233-123
display initcauses
Help Messages
If the system technician presses HELP after entering “display initcauses” the
following message appears:
[’print’ or ’schedule’]
Error Messages
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
display memory-configuration
Help Messages
If the system technician presses help after entering “display
memory-configuration” the following message appears:
Enter [‘long’] [‘print’ or ‘schedule’]
Error Messages
If “display memory-configuration” is executed, the following error message will
appear on the SAT status line:
“memory-configuration” is an invalid entry; please press HELP
If ““display memory-configuration long” is executed on a simplex system, the
following error message will appear on the SAT status line:
”long” is an invalid identifier; please press HELP
If “display memory-configuration long” is executed when the standby processor is
not available, the following message will appear on the SAT status line:
Cannot access the standby SPE at this time
To Next Page
Loading...
