reset board
Issue 4 May 2002
A-75 555-233-123
If the specified trunk group is not administered or has no members, the following
message appears:
Group not assigned,
or group assigned but with no member
If the specified member is not administered, the following message appears:
Group member not assigned
If the specified trunk group is part of the SCI link, the following message appears:
Cannot busyout/release part of SCI link
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
reset board
Help Messages
If the system technician presses HELP after entering “reset board,” the following
message appears:
Enter board location, [’repeat’ (1-100)]
Error Messages
If the format of the board location is incorrect, the following error message
appears:
Port/Board invalid
If the EPN on which the specified board is not available, the following message
appears:
EPN is not available
To Next Page
Loading...
