Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-62 Issue 4 May 2002
If the EPN on which the board resides is not available, the following message
appears:
EPN is not available
If a board is not inserted in the specified location, the following message appears:
Board not assigned
If the specified board does not have any maintenance objects associated with it,
the following message appears:
No MO in this board
If the specified board is a EI board and it is part of the active link, the following
message appears:
Illegal Command for active object; use ’set’ to switch to
standby
If a reset is attempted on an invalid board in the service slot, the following
message appears:
Board invalid
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
release cdr-link
Help Messages
If the system technician presses HELP after entering “release cdr-link,” the
following message appears:
Enter ’primary’ or ’secondary’
To Next Page
Loading...
