get ethernet options
Issue 4 May 2002
8-135555-233-123
Field descriptions
get ethernet options
Use this command to generate a report about a specific ethernet connection.
Screen 8-14. get ethernet-options screen
Board Type For VAL, this field is TN2501.
FW Vintage The firmware vintage number
HW Signature The hardware signature number
Suffix The circuit pack suffix code letter
Date The date the firmware file was created or transferred to the circuit
pack
Timestamp The time that the firmware file was created or transferred to the
circuit pack
CRC Checksum Cyclic Redundancy Check (data integrity algorithm)
Active Image Yes in this field indicates the active firmware image file.
No in this field indicates the inactive firmware image file.
To change the active image file, use the
set boot-image
command.
Reboot Image Yes in this field indicates that this image becomes active after a
system reset.
No in this field indicates that this image becomes inactive after a
system reset.
Action/
Object Qualifier
Qualifier
Description Logins Defaults
Feature
Interactions
get
ethernet-
options
location The physical location
of the circuit pack
(UUCSS)
init
inads
craft
customer
display ethernet-options 1C07
Administered Value Actual Value
Auto Negotiation: Yes Yes
Speed: N/A 10Mbps
Duplex: N/A Full
Link Integrity: Active
To Next Page
Loading...
