Avaya Definity SI - Status Packet-Control; Status Periodic-Scheduled

Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-104 Issue 4 May 2002
status packet-control
Help Messages
If the system technician presses HELP after entering “status packet-control”, the
following message appears:
Enter Packet Control location:
[cabinet(1)];carrier(A-B)
Error Messages
If this command is entered for a packet-control that resides on the stand-by
control complex of a High or Critical Reliability System, the following message
appears:
Command only applies to the active Packet Control
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
status periodic-scheduled
This command displays the status of periodic and scheduled maintenance testing
performed by the system.
Help Messages
If the system technician presses HELP after entering “status period-scheduled”, the
following message appears:
[’print’]
Error Messages
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit.
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later.