test led
Issue 4 May 2002
A-131 555-233-123
test led
Help Messages
If the system technician presses HELP after entering “test led” the following
message appears:
Enter [’all’ or ’cabinet’ (1-3)],
[’long’ or ’short’ ], [’repeat’ (1-100)]
Error Messages
If there is an error in the input to the command, where “x” is the invalid input, the
following message appears:
“x” is an invalid identifier;
press RETURN to execute modified command
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
test link
Help Messages
If the system technician presses HELP after entering “test link” the following
message appears:
Enter link number(1-8), [’long’ or ’short’],
[’repeat’ (1-100) or ’clear’], [’schedule’]
Error Messages
If the link number is not within the valid range, then the following error message
appears:
Link out of range, please press HELP
If the link has not been administered, then the following message appears:
Link not administered or not enabled
If there are no tests for the current MO, the following message appears:
No tests for this MO
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
To Next Page
Loading...
