clear interface
Issue 4 May 2002
A-29 555-233-123
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
clear interface
Help Messages
If HELP is pressed after entering “clear interface,” the following message appears:
Enter location: [cabinet(1)], carrier(A-B), pos(1-2)
Error Messages
If the specified carrier is not the active PE, the following message appears:
Command must be executed from active SPE
If the cabinet and carrier is invalid for a PPN, the following message appears:
Invalid port-network specified
If the carrier is not a valid carrier, the following message appears:
Invalid carrier specified
If the technician-entered carrier is not active, the following message appears:
Board invalid
If there is not a PI circuit pack administered for the specified position, but the
specified carrier is active, the following error message appears:
Processor Interface (TN765) not started or is being started
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
To Next Page
Loading...
