Avaya Definity SI - Set Boot-Image

Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-284 Issue 4 May 2002
Field descriptions
set boot-image
Use this command to direct the system to use 1 of 2 possible firmware image files
on the TN2501AP circuit pack.
NOTE:
You must reseat the circuit pack before the firmware file specified in this
command becomes the active boot image.
Processor
Identifies the processor carrier where translation data
saves. (SPE-A, or SPE-B.)
Command Completion
Status
Displays a variety of messages, identifying the
success or failure of the command.
Action/
Object Qualifier Qualifier Description Logins Default
Feature
Interactions
set boot-
image
location
1
2
The physical location of the circuit pack
(UUCSS)
Directs the system to use the Image 1
firmware file
Directs the system to use the Image 2
firmware file
Example
set boot-image board 1B08
init
inads
craft
customer
save translation
SAVE TRANSLATION
Processor Command Completion Status Error Code
SPE-A Success 0
SPE-B Success 0
Command Successfully Completed