Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-134 Issue 4 May 2002
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
test modem-pool
Help Messages
If the system technician presses HELP after entering “test modem-pool” the
following message appears:
Enter group #(1-5) or group #/member #,
[’long’ or ’short’], [’repeat’ (1-100)],
[’schedule’] or press CANCEL to cancel the command
Error Messages
If the “test modem-pool” command is entered from a login for which the command
is not valid, then the following message appears:
“test” is an invalid entry; please press HELP
If the group or member numbers entered are not digits, then the following
message appears:
Identifier invalid
If the group number or member number entered is not within the valid range of
groups or members, the following message appears:
Boards not assigned
If the group is not administered or is administered but with no members, the
following message appears:
Group not assigned, or group
assigned but with no member
If the a member is assigned, but the port is does not exist in the system, then the
following message appears:
Port not assigned
If there are no tests found for the maintenance object, the following message
appears:
No tests for this MO
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
To Next Page
Loading...
