list mst
Issue 4 May 2002
8-177555-233-123
Field descriptions
list mst
This command displays the messages in the trace buffer and can be used when
the trace is disabled or active, but if active, older messages may be sporadically
omitted if wraparound is selected and the message rate is high. The command
can be used repeatedly without destroying the integrity of the buffer.
Sig Grp No
The group number, rank ordered.
Region
The network region of the group.
Hour Average
Latency (ms)
The average latency for the whole hour.
Hour Packets Sent
The number of packets sent during the whole hour.
Hour Packets%
Lost
The percent lost packets for the whole hour (if 100% the
corresponding latency is shown as ****).
Hour & Worst
Interval
The hour and worst 3 minute interval within the hour. (The
interval is identified by the last minute of the interval.)
Interval Average
Latency (ms)
The average latency for the interval.
Interval Packets
Sent
The number of packets sent during the interval.
Interval
Packets % Lost
The percent lost packets for the interval (if 100%, the
corresponding latency is shown as *****).
Action/
Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
list mst from
message
number
count number
Message number to start
the display; if the number is
not in the buffer, then that is
indicated on the display,
and no additional
messages are displayed.
Omitting this qualifier
causes messages to be
displayed starting with the
oldest FIFO and continuous
messages.
Message count; can be
used to limit the trace
init
inads
FIFO
order
See system
printer
documentation.
To Next Page
Loading...
